Potential availability of metals in anaerobic mono- and co-digestion of pig manure and maize.

This study aims to analyse the potential availability of essential metals including as Co, Fe, Ni, Zn, Mn, and Cu and non-essential metals such as Pb, Cr, and Cd within anaerobic mono- and co-digestion of pig manure and maize. The metals partitioning was determined using the Modified BCR (European Community Bureau of Reference) sequential extraction at defined intervals over a 45-days period, correlating changes in metals speciation with key digestion variables. The findings revealed that Cr, Cu, Fe, and Pb were predominantly associated with the oxidisable fraction, while Zn, Mn, and Cd were potentially available in both processes. Notably, NH4+-N and the VFAs, except propionic acid, correlated significantly with the available fractions of Co, Mn, Ni, Zn, Cr, and Pb during mono-digestion of pig manure. The wider pH range and the chemical properties of the feedstock in co-digestion resulted in varied correlations between the metals availability and the digestion variables.

The Influence of Poultry Manure-Derived Biochar and Compost on Soil Properties and Plant Biomass Growth.

Promising methods for managing poultry manure (PM) include converting poultry manure through pyrolysis to biochar, which can be used for soil applications. The overall goal of this study was to determine the effects of poultry manure-derived biochar and compost on the soil and growth of cherry tomatoes. The biochar obtained at 475 °C was characterized by a relatively high organic matter content of 39.47% and nitrogen content of 3.73%, while it had the lowest C/N ratio of 8.18. According to the recommendations of the EBC, the biochar obtained at 475 °C demonstrated the most beneficial effects in terms of fertilizing potential. The composting of poultry manure with the straw was successful, and the limit of 60 °C was exceeded, which allowed for the hygienization of the compost. The produced compost and biochar are sanitary safe and do not exceed the limits of heavy metal content. The lowest plant biomass was obtained from growing medium A with 3.6 g wet weight (0.24 g dry weight). The measurements of the height of cherry tomatoes showed that growing media D, E, and F allowed the plants to obtain from 602 to 654 mm in height.

Development of conversion factors to estimate the concentrations of heavy metals in manure-derived digestates.

During biogas production, a residual by-product rich in organic matter, nutrients, and trace elements - called digestate - is generated. Due to the nature of the anaerobic digestion process (i.e., conversion of organic matter into biogas) and the non-digestibility of trace elements, metal concentrations are higher in digestate than initially in the treated feedstock, resulting in a detrimental effect on the environment when directly applied as fertiliser on the soil. This study aims to predict the concentration of heavy metals in digestate through four different process parameters (Biogas yield - M1, Biodegradable fraction - M2, Dry matter - M3 and Power generation - M4) in full-scale biogas plants. For the validation of the process parameters, the predictions were compared against laboratory analyses of feedstocks and digestates samples from mono- and co-digestion processes. The convergence between the conversion factors based on laboratory data and process parameters (CLD and CFA, respectively) ranged in the following order: M3 > M2 > M1 > M4. Based on laboratory analyses, better predictions were obtained for Al, Cr, Cu, Fe, Mn, and Zn employing M3. Moreover, a robust convergence was achieved between the CLD and CFA conversion factors for the mono-digestion process. Further assessment of a diverse range of feedstocks is needed to increase the convergence between the conversion factors based on process parameters and laboratory data, specifically for the co-digestion process M3. The concentrations of Cd, Co, Ni, and Pb elements were below the detection limits, whereas Cr, Cu, and Zn did not exceed the legal threshold limits of the legislations.

Improving biochar properties by co-pyrolysis of pig manure with bio-invasive weed for use as the soil amendment.

Over recent years, pyrolysis has grown into a mature technology with added value for producing soil improvers. Further innovations of this technology lie in developing tailor-made products from specific feedstocks (or mixtures thereof) in combination with adjusted mixing ratio-temperature regimes. In this context, co-pyrolysis of pig manure (PM) and the invasive plant Japanese knotweed (JK) at different mixture ratios (w/w) of 3:1 (P3J1), 1:1 (P1J1), and 1:3 (P1J3) and varying temperatures (400-700 °C) was studied to address the low carbon properties and heavy metals (HMs) risks of manure-derive biochars and beneficially ameliorate the bio-invasion situation by creating value from the plant biomass. Co-pyrolysis of PM with JK increased by nearly 1.5 folds the fixed carbon contents in the combined feedstock biochars obtained at 600 °C compared with PM-derived biochar alone, and all combined feedstock biochars met the requirements for soil improvement and carbon sequestration. The total HMs in PM biochars were significantly reduced by adding JK. The combined feedstock biochar P1J1 generated at 600 °C was the most effective in transforming Cu and Zn into more stable forms, accordingly reducing the associated environmental risk of heavy metal leaching from the biochar. In addition, the accumulation of macronutrients can be an added benefit of the co-pyrolysis process, and P1J1-600 was also the biochar that retained the most nutrients (P, Ca, Mg, and K).

Struvite-based composites for slow-release fertilization: a case study in sand.

Struvite (St) recovered from wastewaters is a sustainable option for phosphorus (P) recovery and fertilization, whose solubility is low in water and high in environments characterized by a low pH, such as acidic soils. To broaden the use of struvite in the field, its application as granules is recommended, and thus the way of application should be optimized to control the solubility. In this study struvite slow-release fertilizers were designed by dispersing St particles (25, 50, and 75 wt%) in a biodegradable and hydrophilic matrix of thermoplastic starch (TPS). It was shown that, in citric acid solution (pH = 2), TPS promoted a steadier P-release from St compared to the pure St pattern. In a pH neutral sand, P-diffusion from St-TPS fertilizers was slower than from the positive control of triple superphosphate (TSP). Nevertheless, St-TPS featured comparable maize growth (i.e. plant height, leaf area, and biomass) and similar available P as TSP in sand after 42 days of cultivation. These results indicated that St-TPS slow P release could provide enough P for maize in sand, achieving a desirable agronomic efficiency while also reducing P runoff losses in highly permeable soils.

Impact of time and phosphorus application rate on phosphorus bioavailability and efficiency of secondary fertilizers recovered from municipal wastewater.

Demand for phosphorus (P) resources other than non-renewable P rock has driven the development of several P recovery technologies from municipal wastewater treatment and directed recovery of P into valuable fertilizers (struvite, ash, iron phosphate, etc.). Although the bioavailability of novel secondary P fertilizers has been examined in previous studies, insufficient attention has been paid to defining optimal plant growth duration and monitoring conditions to assess the dynamic changes in P. Accordingly, five fertilizers recovered from municipal wastewater: two struvites (STRSL and STRLQ), two ashes (ASH1 and ASH2), and iron-phosphate pelletized sludge (FeP) using triple superphosphate (TSP) as a positive control and blank (zero P) as a negative control, were applied to P poor-sand at three P doses (equivalent to 30, 60, and 90 kg P2O5 ha-1). Fertilizer impact on perennial ryegrass (Lolium perenne) dry matter (DM) and P concentration were evaluated on a monthly basis for seven months. DM and relative agronomical efficiency (RAE) have shown the same trend between the fertilizers, but only at the lowest P dose (corresponding to 30 kg P2O5 ha-1). At higher P doses (60, and 90 kg P2O5 ha-1) the differences in DM and RAE among the fertilizers diminished. STRLQ, STRSL, ASH1 and FeP expressed a rather steady P release pattern, while ASH2 had a delay of four cuts and increase afterward. Monitoring the P uptake during four months of perennial ryegrass growth turned out to be the minimum, and seven months the optimum period for reaching the full capacity of the slow-release P fertilizers.

Effect of pyrolysis temperature on removal of organic pollutants present in anaerobically stabilized sewage sludge.

Sewage sludge was excluded from the list of component materials for the production of EU fertilizing products and it was banned as feedstock to produce pyrolysis & gasification materials in European Commission's technical proposals for selected new fertilizing materials under the Regulation 2019/1009 (STRUBIAS report). This exclusion of pyrolysis as a viable way to treat sewage sludge was mainly due to the lack of data on the fate of organic pollutants at pyrolysis conditions. In this work, we are addressing this knowledge gap. We studied slow pyrolysis as a potential process to efficiently treat organic pollutants present in stabilized sewage sludge. Sewage sludge was pyrolyzed in a quartz fixed bed reactor at temperatures of 400-800 °C for 2 h and the sludge and resulting sludge-chars were analyzed for the presence of four groups of organic pollutants, namely (i) polychlorinated biphenyls (PCBs), (ii) polycyclic aromatic hydrocarbons (PAHs), (iii) pharmaceuticals, and (iv) endocrine-disrupting and hormonal compounds. Pyrolysis at ≥ 400 °C effectively removed pharmaceuticals (group iii) to below detection limits, whereas pyrolysis at temperatures higher than 600 °C was required to remove more than 99.8% of the compounds from groups i, ii and iv. Based on these findings, we propose, that high temperature (>600 °C) slow pyrolysis can satisfactory remove organic pollutants from the resulting sludge-char, which could be safely applied as soil improver.

Effect of Applying Struvite and Organic N as Recovered Fertilizers on the Rhizosphere Dynamics and Cultivation of Lupine (Lupinus angustifolius).

Intensive agriculture and horticulture heavily rely on the input of fertilizers to sustain food (and feed) production. However, high carbon footprint and pollution are associated with the mining processes of P and K, and the artificial nitrogen fixation for the production of synthetic fertilizers. Organic fertilizers or recovered nutrients from different waste sources can be used to reduce the environmental impact of fertilizers. We tested two recovered nutrients with slow-release patterns as promising alternatives for synthetic fertilizers: struvite and a commercially available organic fertilizer. Using these fertilizers as a nitrogen source, we conducted a rhizotron experiment to test their effect on plant performance and nutrient recovery in lupine plants. Plant performance was not affected by the fertilizer applied; however, N recovery was higher from the organic fertilizer than from struvite. As root architecture is fundamental for plant productivity, variations in root structure and length as a result of soil nutrient availability driven by plant-bacteria interactions were compared showing also no differences between fertilizers. However, fertilized plants were considerably different in the root length and morphology compared with the no fertilized plants. Since the microbial community influences plant nitrogen availability, we characterized the root-associated microbial community structure and functionality. Analyses revealed that the fertilizer applied had a significant impact on the associations and functionality of the bacteria inhabiting the growing medium used. The type of fertilizer significantly influenced the interindividual dissimilarities in the most abundant genera between treatments. This means that different plant species have a distinct effect on modulating the associated microbial community, but in the case of lupine, the fertilizer had a bigger effect than the plant itself. These novel insights on interactions between recovered fertilizers, plant, and associated microbes can contribute to developing sustainable crop production systems.

Tomato plants rather than fertilizers drive microbial community structure in horticultural growing media.

Synthetic fertilizer production is associated with a high environmental footprint, as compounds typically dissolve rapidly leaching emissions to the atmosphere or surface waters. We tested two recovered nutrients with slower release patterns, as promising alternatives for synthetic fertilizers: struvite and a commercially available organic fertilizer. Using these fertilizers as nitrogen source, we conducted a rhizotron experiment to test their effect on plant performance and nutrient recovery in juvenile tomato plants. Plant performance was significantly improved when organic fertilizer was provided, promoting higher shoot biomass. Since the microbial community influences plant nitrogen availability, we characterized the root-associated microbial community structure and functionality. Analyses revealed distinct root microbial community structure when different fertilizers were supplied. However, plant presence significantly increased the similarity of the microbial community over time, regardless of fertilization. Additionally, the presence of the plant significantly reduced the potential ammonia oxidation rates, implying a possible role of the rhizosheath microbiome or nitrification inhibition by the plant. Our results indicate that nitrifying community members are impacted by the type of fertilizer used, while tomato plants influenced the potential ammonia-oxidizing activity of nitrogen-related rhizospheric microbial communities. These novel insights on interactions between recovered fertilizers, plant and associated microbes can contribute to develop sustainable crop production systems.